|
SpartaDOS X Reference Manual |
The Command Processor — Commands |
| VERIFY Command |
| Purpose |
To turn write verify on or off. |
|
| Syntax | VERIFY ON|OFF |
|
| Type | Internal |
|
| Remarks | When ON, SpartaDOS performs a verify operation following each disk write operation, to verify that the data just written can be read without error. This only applies to floppy drives. Because of the extra time required to perform the verification, the system runs much slower when programs write data to disk. The default is OFF — this command is typically used when you are having floppy drive problems. |
| Previous page |